Application Tips and Advice

Connectric Application Tips and Advice

RSS
PREVENT PREMATURE FAILURE OF ENCODERS
Isolation inserts can prevent current flow through the encoder bearings, preventing pitting and premature bearing wear.
Read More
NEW !!  SIMULTANEOUS DISPLAY AND CONTROL OF POSITION & SPEED ON A SINGLE DISPLAY WITHOUT THE NEED OF A PLC AND HMI.
Display Position and Speed simultaneously on a single Display / Controller
Read More
EASY LENGTH , SPEED, COUNT, PROCESS MEASUREMENT AND CONTROL
Easy Length Measurement & Cut Control, Speed Measurement & Control, with NO PLC, NO HMI, NO EXTERNAL POWER SUPPLY, NO PROGRAMMING EXPERIENCE
Read More
Easy Single Axis Position Controllers for Low-Cost Solutions PS340 / PS641
The PS340 / PS641 from Motrona is an accurate yet economical single axis positioning controller. The built in display provides feedback, and can be used to program the controller and set positions.
Read More
EASY 2 AXIS SPEED AND PHASE SYNCHRONIZATION BY340 / BY641
Easy yet sophisticated synchronization of speed and phase of conveyors, different machinery, etc.
Read More
DATA LOGGING OF PROCESS ANALOGUE SIGNALS
The UZ210 is a versatile converter from process analogue signals to RS232 & RS485 for data logging. The scalable outputs with linearization capability allows data logging of the process being measured in scale values (not just logging analogue values)
Read More
Fiber Optic Data Transmission for encoder and sensor signals over electrically noisy, explosive areas or long distances
Need to transmit incremental encoder, sensor or SSI signals through electrically noisy environments, explosive areas, or over long distances? Fiber optic transmitters and receivers from Motrona could provide the solution.
Read More
SSI / ABSOLUTE ENCODER SPLITTER
Need to split an SSI / absolute encoder signal or convert SSI to analogue? The Motrona IX350/IX355 will provide master control plus provide a display of position.
Read More
TAMPER RESISTANT & WASH DOWN AUDIBLE ALARMS
Audible alarms are used on many machines and panels.  Many have the retaining nut on the face of the panel.  The retaining nuts can be loosened and removed by operators, and the buzzers can fall into the panel.Auer Buzzers mount in standard 22 mm holes, and are mounted from the front of the panel, with the retaining nut and optional anti-rotational washers mounted from the rear.  This makes them tamper resistant.  Additionally, many of these buzzers have a removable terminal ...
Read More
FAILSAFE E-STOPS
E-Stops are used to stop machinery or processes quickly.  They usually have one or more  normally closed contacts which are opened when the E-Stop is activated.  If the normally closed contact block falls off the activator, the contacts remain closed, pressing the E-Stop will not stop the equipment.  Of course, a block that is not attached to the activator is not visible from the front of the panel.The Guardian block from Sprecher & Schuh eliminates this problem.  Th...
Read More
Page 1 of 2 FirstPrevious [1]
  • Back to top